Alcatel OmniPCX Office is also called OXO.

Configure the PBX

In Alcatel Lucent OmniPCX Office Management Console (6.x.x.x) – (called PCXTools OMC 600)

Counting > Counting >
- select “Accounting Printout”" tab:
  - check and select Ext. Accounting Activation IP
  - check “Print un-answered IC Calls”
  - uncheck “Masking of 4 last digits”
  - Type of printout “Ticket”
  - Language “English”
- select Accounting Options for Active Currency
  - Display on sets: “Duration+Units”
Network Management Control > Centralized Management
- Active call accounting for: Incoming&Outgoing calls

Alcatel OmniPcx Office Release 1.x-4.x (OXO)

The default address of the pbx system is 192.168.0.254 and the port for ftp is 30021. You need to set in the PbxMon setup in the remote server address:port the following string: 192.168.0.254:30021. Also you must use user ftp_nmc and password tuxalize.

Currently PbxTools PhoneJournal is the only independent software that supports IP data collection from OXO 1.x-4.x

Alcatel OmniPcx Office Release 5.x-6.x (OXO)

Yes, the newest Alcatel OXO models can’t be used for call accounting without ordering something from Alcatel.

The method used with previous models does not work anymore. You must choose one of the following alternatives:

Buy/use the V24 serial interface – (cost ~150-250 EUR)
Buy/use the SWL CALL ACCOUNTING OVER IP (Metering License) – Product code: 3EH03177AA – would cost under 100 EUR. This license is required in order to be able to use Alcatel OHL Driver that is required by PbxTools PhoneJournal in order to work with 5.x or newer OXO units.

Now it seams to be impossible to record call accounting data via IP without ordering a Metering License for CAPInterface and using

OHL Driver (doesn’t work if you do not have the metering license inside OXO)

Alcatel OmniPCX Enterprise (OXE)

If you want to know what software release do you have on 4400 please login using telnet, user mtcl passwordmtcl an run the command siteid.

Alcatel OmniPcx Enterprise and 4400 (OXE)

The default address of the pbx system is 192.168.0.254 and the port for ftp is 21. You need to set in the PbxMon setup in the remote server address:port the following string: 192.168.0.254:21. Also you must use user mtcl and password mtcl.

Alcatel 4200 E

You have to do the following settings using your Alcatel programming software (MMC).

If you don’t have a cable you’ll need to make the wiring directly on the CM board.

Connect X7, X8 : 10 pin BURNDY connector for connecting a pulse metering device (X7) and the MMC PC (X8). The terminals connected to these interfaces must be classified S.E.L.V.

Pin no.	Signal	Function
1		REMOTE		Signal used for remote access
2		RXD 		104 - Reception
3		TXD 		103 - Transmission
4		DTR 		108 - Data Terminal Ready
5		0V 		Ground
6		DCD		109 - Carrier Detection
7		RTS		105 - Request To Send
8		CTS		106 - Clear To Send
9		0V		Ground
10		GND		102 - Signalling Ground

[Show as slideshow]